KEMPER Filter cartridge - 350x600 mm - PTFE coating - 10 m² for KEMPER

Replacement filter as a replica, alternative to KEMPER 1090335

Filter cartridge in the dimensions 350 x 600 mm for use in:
 

• KEMPER System 8000 (from 11/2007)
• KEMPER WeldFil compact
• KEMPER PlasmaFil (short Filter cartridges)
• KEMPER KemJet
• KEMPER VacuFil 500, 2000, 4000

High-performance Cleaning filter made of Polyester fleece with PTFE coating and a Filter area of 10 m². The non-stick coating with PTFE ensures very good cleanability of the Filter material. The filter cartridge complies with Dust classification M, tested in accordance with DIN EN 60335-2-69:2010 Annex AA, and achieves a very high filter efficiency of ≥ 99.9%. The Filter cartridge is open at the top, the bottom is closed except for a 13 mm hole for fastening. The Filter medium is cast in synthetic resin at the top and bottom. A belt wrapped spirally around the metal support basket prevents contact between the Filter medium and the support basket, but allows the necessary mobility for cleaning using rotary nozzles.

Recommendation: In addition to this polyester fleece cartridge with a PTFE coating, we recommend the use of precoat - filter powder, which is also available an accessory in our webshop Initial treatment of the filter with Precoat filter poweder increases the service life of the filter and improves cleaning efficiency.

Important note: KEMPER replica. Only for KEMPER systems. Optimized filter for KEMPER extraction systems with rotary nozzles. Do not use for systems from other manufacturers with JET Pulse cleaning, even if the dimensions appear to fit. You can find special filter cartridges with the same dimensions but a different design in the filter.shop.

Warranty retention when used in KEMPER devices

All Replica filters in the filter.shop are tested and approved by KEMPER. The device warranty is therefore retained when our Replica filters are used in KEMPER devices.